Tile & Grout Cleaning and Sealing 

dirty tileWe professionally clean  and restore all types of ceramic tile, stone and grouting surfaces including floors, counter tops, vinyl floors and showers/bathroom surfaces. We use state of-the-art van-powered cleaning methods specially designed for tile and grout.

Our process includes: 

  1. Inspection of tile surfaces examining for the best possible cleaning method.
  2.  
  3. Specialty heated “Clean Green” tile pre-conditioners and hand brushing, first to loosen embedded soils on the surface of the tile and grout.
  4.  
  5. Turbo Force cleaning tools used with hot steam and high pressure with rotating head cleaner using only force of steam with “Clean Green” tile detergents and powerful high velocity extraction of all soil and water.
  6.  
  7. Thoroughly dry all surfaces.
  8.  
  9. Apply an optional Grout Sealer to protect grout from mildew and re-soiling.

Pre-Treatment

First, we apply a mild alkaline solution to a section of the floor and allow it to soak for approximately 15 minutes. In severe case of soiling we will use a rotary floor machine to agitate the clearing agents in. This pre-treatment loosens accumulated soil, grease, and contaminants, and prepares the surface for our cleaning process. The alkaline solution does not produce any harmful fumes, and ordinary ventilation removes the mild scent within minutes of completion of the job. If necessary we will use a safe gentle acid to attempt to remove any staining that did not come out with the alkaline cleaning agent.

Turbo Pressure Washing

We use a pressure washing system designed specifically for tile & grout, acrylic, and epoxy surfaces. Our truck mounted cleaning process power washes the floor to extract soil and grease from the pores of the tile and grout or other hard surface floors. The system generates water pressure of 0 to 3,000 P.S.I. and water temperature of approximately 275 degrees to soften and extract years of soil and contaminants.  The floor tool connects to a powerful vacuum hose, which sucks the cleaning disk to the floor, and confines the water spray inside the 16-inch disk. There is virtually no splash over to worry about. The vacuum hose draws away the water, along with the dirt, to a containment tank on our truck, and we dispose of the wastes in accordance with EPA regulations. You will find that our process restores the tile & grout to 85 to 90 percent of its original appearance. Some stains, (red wine, mustard, dyes, etc.) will not come out because they dye the grout, but the combination of heat, water pressure, and suction removes most stains.

Optional Sealing

After we clean the floor and allow it to dry, we seal the floor with our impregnating sealer. The tile & grout floor absorbs the sealer into its pores, creating a barrier against future staining. The sealer does not change the appearance of the floors by adding a shine or luster. Instead, it preserves the natural beauty of the surface.

tile cleaner